Back
JessEm Mast R Slide
The Ultimate Cross-Cutting Accessory
For Your Table Saw!
 
Features:
tab Take your table saw to higher level of precision and performance with the Mast-R-Slide™ sliding cross-cut table from JessEm Tool Company
tab This fine quality table saw system features a network of engineered aluminum extrusions, steel guide rails and precision bearings.
tab Designed to replace the left extension wing on most cabinet saws and contractor saws with cast iron table tops
tab The guide mechanism is comprised of 30 double-sealed precision bearings positioned in a staggered design to provide constant contact to the guide rails throughout its travel
tab The sliding table is easily adjustable to level with the saw's tabletop and to align it parallel to the cutting blade
tab Also included is an extension wing support table that is fully adjustable for positioning in a fixed location anywhere along the length of the sliding table
tab The extruded aluminum fence length is 711mm closed and extends outward for a maximum measured cut length of 1219mm with the flip-stop
tab The fence offers mitered cross-cuts up to 45 degrees in both direction
tab The Mast-R-Slide™ sliding table offers three position for the fence, two front end positions for (one optimal location for mitered crosscuts and another allowing for an increased cutting width at 90 degrees) and a rear end position for a maximum cross-cut capacity of 36 inches     Contact us  
tab Designed so that no support legs are required, offering a smaller footprint and allowing the optional use of a mobile base on the saw  
$799.00 Inc GST
tab The Mast-R-Slide™ will fit right or left tilt table saws and is designed to be used on the left side of the saw. The table saw must have a solid cast iron top and the front and rear fence rails require modification  
   
Technical Information:    
tab Maximum Stroke 940mm  
tab Length of cut off fence 940mm  
tab Length of cut with fence extended 1219mm      
tab Length of rail system 686mm  
tab Sliding table dimensions    
tab Outrigger table dimensions 216mm x 216mm    
tab Sliding table width including outrigger 416mm    
tab Maximum cross-cut with fence in front position 863mm *    
tab Maximum cross-cut with fence in middle position 635mm *    
tab Maximum cross-cut with fence in rear position 915mm *  
tab Unit Weight 22kg  
 
* Actual cross-cut capacities may vary as the position of the saw blade varies from saw to saw.